浙江聚丙

使用微信掃描二維碼分享朋友圈，成交更快更簡單！

1. 洗煤廢水澄清劑陽離子聚丙烯酰胺CPAM

博源凈水實驗室對絮凝法處理洗煤廢水的實驗研究也曾做過千余次實驗，對洗煤行業有豐富的經驗。一般，洗煤廢水水量較大,色度大,污染性強。博源實驗室分別對陰離子型、非離子型、陽離子型三種有機高分子聚丙烯酰胺絮凝劑進行配比實驗，比較廢水處理效果,發現都不是非常理想。實驗人員又將無機凝聚劑與這三種有機高分子絮凝劑復配使用,發現效果很好;有機高分子絮凝劑用量少,產生絮體時間短,礬花大而實,沉降快。通過實驗得出適宜的絮凝條件:100 mL廢水陰離子型聚丙烯酰胺的投加量0.001 g,硫酸鈉為0.06 g,pH為9.7,攪拌時間為20 min。在此條件下堿廠廢水COD去除率達到80.5%。廢水的色度去除率為92.9%。可以完全滿足洗煤廢水處理效果。作為洗煤廢水澄清劑使用的聚丙烯酰胺的減量投放，大大降低了運營成本。

陰離子聚丙烯酰胺 Anionic Polyacrylamide

產品特性 Product Features

該產品采用前加堿聚合后水解制備方法，在聚合時加入多元引發劑，并通入二氧化碳控制聚合體系值。產品外觀呈白色顆?；蚍勰┕腆w狀。能以任意比例溶解于水且不溶于有機溶劑。有效的pH值范圍為7到14，在中性堿性介質中呈高聚合物電解質的特性，與鹽類電解質敏感，與高價金屬離子能交聯成不溶性凝膠體。

This product adopts adding alkaline before polymerization and hydrolysis after polymerization. Add multiple initiators during polymerization and control polymerization system value by carbon dioxide. Product appearance is white particles or powder. It can dissolve in water in any proportion but insoluble in organic solvents. The effective pH range is 7 to 14 and it shows the characteristics of high polymer electrolyte in a neutral or alkaline medium. Also it is sensitive to salts electrolyte and can stitch insoluble gel with high metal ions.

非離子聚丙烯酰胺 Nonionic Polyacrylamide 

產品特性Product Features

該產品是丙烯酰胺單體的均聚物，經造粒、干燥、粉碎而成，離子化程度低。產品外觀呈白色顆?；蚍勰┕腆w狀。絮凝性能受水pH值和鹽類波動的影響小。在酸性條件下優于陰離子型，絮凝強度比陰離子型高分子絮凝劑的強。

The product is the polymer of acryl amide monomer which formed after granulation, drying and crushing , with low degree of ionization. The product appears white solid particles or powder. Flocculation performance is affected little by the fluctuation of the water pH and salt. It is better than anionic under acid condition and flocculation strength is better